| Model |
LH71-1 |
LH71-2 |
LH71-3 |
| Display |
7 digits and minus display |
| Connectable measuring unit |
GB-ER, PL20C,SJ700A (Direct) / DG-B (Necessary to use the conversion adaptor which is sold separately) |
| Measuring unit input resolution |
Standard： 0.1 µm, 0.5 µm, 1 µm, 5 µm, 10 µm, 1 s, 10 s, 1 min, 10 min
Expanded： 100 µm, 50 µm, 25 µm, 20 µm, 2 µm, 0.05 µm, 1 degree can be added |
| Display resolution |
Measuring unit input resolution or higher and diameter display (except for angle display) |
| Input signal |
A/B quadrature signal, Z signal |
| Minimum input phase difference |
100 ns |
| Quantization error |
±1 count |
| Alarm display |
Measuring unit disconnected, Excess speed, Maximum display amount exceeded, Power failure, Error in stored data |
| Reset |
Resettable by key switch |
| Preset |
It is possible to store/call 3 kinds of numbers. |
| Reference point detection |
The reference point of the measuring unit can be detected, and the datum point can be relocated (during connection of measuring unit with a reference point) |
| Data storage |
The value displayed before the power was turned off and setting values are stored |
| Linear error compensation |
A fixed compensation is applied to the measuring unit’s count value. Compensation amount Standard: ±600 µm/m (Expanded: ±1000 µm/m) |
| Segmented error compensation |
The movement range of the measuring unit with a reference point can be divided into a maximum of 32 sections, and error compensation is performed for each of these sections. Compensation amount: ±600 µm (at each section) |
| Scaling |
Scaling factor：0.100000 ～ 9.999999 |
| Program |
- Machining coordinates can be programmed (number of program steps: 850 max.)
- 1. Manual programming by key switch
- 2. Automatic programming by playback
- 3. Mirror image during program execution
- 4. A canned cycle (bolt hole, line hole, simple R cutting) can be inserted in the program
|
| Angle display |
Can be displayed as an angle value when the Digiruler is pasted to the arc surface, and the diameter and Digiruler resolution are entered |
| Sleep |
The display is turned off when no operations are made for a preset time. (The time can be set.) |
| Power supply |
DC 12 V Rating 0.75 A Max. 1 A AC 100 V to 240 V ±10 % When using the AC adaptor PSC-22A (For U.S. only) or PSC-23A (For Europe and other countries) *Option |
| Power consumption |
max.32 VA (connected at the AC adaptor.) |
| Operating temperature |
0 ～ 40°C (no condensation) |
| Storage temperature |
－20 ～ 60°C (no condensation) |
| Mass |
Approx. 1.5 kg |
